i want to produce a code in which i can
control two heaters and also i should have feedback signal via
temprautre's sensors to be able to control the temperature of the
objekt.
i didn't descide yet which sensor i should use but i want to ask firstly how can i make this code
the princip is to switch two contactors( which connected to the heaters ) via
relays modul( NI PXI 2565 general purpose relay switch ) using
Labview version 7.1 and when the temperatur excedes the required value
the two heaters should be switched off
the sensors will be connected to the device( NI 4351 temperature / voltage )