Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

setting legend channel names in diadem

setting legend channel names in diadem

‎12-21-2010 04:54 PM

How do you input values from LabVIEW to DIAdem using the DIAdem express to set the names of the channels?  Currently my channels all same untitled

-Regards

eximo
_______________________________________________
UofL Bioengineering M.S.
Neuronetrix

"I had rather be right than be president" -Henry Clay
Download All
0 Kudos
Message 1 of 2
(2,097 Views)
Reply

Re: setting legend channel names in diadem

‎12-30-2010 05:37 PM

Hi there,

 

I believe that you just need to wire the signal names to the respective input of the "Set Dynamic Data Attributes VI".

 

 

Regards,
Efrain G.
National Instruments
Visit http://www.ni.com/gettingstarted/ for step-by-step help in setting up your system.
0 Kudos
Message 2 of 2
(2,046 Views)
Reply