Hi
Yes i have downloaded the driver ag3xxx and installed . and also got some advise from
support.india@ni.com
Their comments follows .
Yes you can read the values from the .arb file into LabVIEW and store
the values in 1D array or text file and then send it to the function
generator you are using.
Basically you would have to use APIs such as read from binary
file(there are examples present in LABVIEW example finder which shows an
example of how you could read a binary file.) After reading from the file
you could store its values in an array or a text file and the read from
this array and send the data to the function generator you are using. If
you are using a function generator which is not made by National
instruments you have to install the device drivers for that instrument fro
LABVIEW, you could install them from
www.ni.com/idnet.
i have used some eg: programmes given in LV to read binary files .
The function name is "read binary files vi " . the out put of "read binary files vi "
is data . I am trying to store this data in an array , but got stucked , in finding
a sutable function to send this array valuse to the function generator. Can i send
the array out put directly to a FG ?
Thanks
jith