From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

scan rate using hardware timing.

scan rate using hardware timing.

‎07-09-2003 05:33 AM

How can I set the scan rate accurately to 1000 Hz using hardware timing.
0 Kudos
Message 1 of 2
(2,172 Views)
Reply

Re: scan rate using hardware timing.

‎07-09-2003 12:47 PM

Wire 1000.00 to the Scan Rate input of the AI Start VI. That will set up the scan clock on the DAQ board to run at 1000 Hz. Note that it will only work on NI DAQ boards.

Daniel L. Press
PrimeTest Corp.
www.primetest.com
    
0 Kudos
Message 2 of 2
(2,172 Views)
Reply