keithley 2000/2400 !!! with labview

[Motti F]

hello
I need a control program that will enable me to control all the common
parameters of the 2000/2400 and will enable me to set, control and sample
the measurements using the PC.
For example I need a program that will enable me set and run a sweep on the
2400 and measure it with the 2000 using triggers.

..
* A program that do the following:
# run a sweep with the 2400 - enable the user to configure all the
sweeps parameters
# give a trigger to the 2000,with or without time delay
# the 2000 will sample according to the trigger and store
the samples in buffer or/and send the measurements to the PC
during and in the end.
# the 2400 will be able to also measure his output du
ring sweep
operation.
# all those tests will be done in fast mode .


thank in advance to any one that will answer this add!
motti

[Jared 323]

It took me about 10 seconds to find the 2000 driver on the included CD. No
2400. Look on NI's website.

Jared

"MOT" wrote:
>hello>I need a control program that will enable me to control all the common>parameters
of the 2000/2400 and will enable me to set, control and sample>the measurements
using the PC.>For example I need a program that will enable me set and run
a sweep on the>2400 and measure it with the 2000 using triggers.>>..> *
A program that do the following:> # run a sweep with the 2400 - enable
the user to configure all the>sweeps parameters> # give a trigger to
the 2000,with or without time delay> # the 2000 will sample according
to the trigger and store> the samples in buffer or/and send the
measureme
nts to the PC> during and in the end.> # the 2400 will
be able to also measure his output during sweep>operation.> # all those
tests will be done in fast mode .>>>thank in advance to any one that will
answer this add!>motti>>

[just_me_123@my-deja.com]

I'd say that you need to read the manuals for
these instruments, and learn how to automate the
commands/controls you've initiated from the bench
to do such measurements....rather than have
someone out on the internet do your job FOR you.

btw, I've done what you describe w/2400 & 2000 (+
a '7001 to switch between multiple DUTs), it's
not that hard to do.


Sent via Deja.com
http://www.deja.com/

[Motti F]

Hi
fallowing your comment!

If you think that I'm asking for help without trying myself-that isn't the
case !!!!
first of all I did what you suggeted,and some programs are working right but
I'm still having trouble with the fast reading from the buffers .
second - if you can help me -help, it will save me a lot of time (I mean a
lot) .
third - maybe my add wasn't so clear but still you don't need to be so
negative.

bye
MOT

wrote in message
news:967o3r$764$1@nnrp1.deja.com...
> I'd say that you need to read the manuals for
> these instruments, and learn how to automate the
> commands/controls you've initiated from the bench
> to do such measurements....rather than have
> someone out on the internet do your job FOR you.
>
> btw, I've don
e what you describe w/2400 & 2000 (+
> a '7001 to switch between multiple DUTs), it's
> not that hard to do.
>
>
> Sent via Deja.com
> http://www.deja.com/