how can i make use of signal generated by labview

[sandy10]

please go through the following file and inform me how can i collect the signal from labview inorder to control the heater to switch it ON/OFF.....do i require multisim for taking the signal out from the computer or simply i can directly get it from my daq board

[mcduff]

It looks like the paper you attached gives instructions.

As others have said:

NI Learning Center

NI Getting Started

-LabVEW Basics

3 Hour LabVIEW Introduction

6 Hour LabVIEW Introduction

LabVIEW Graphical Programming Course

[PalanivelThiruvenkadam]

Its always try to do something and make use of forum if you stuck in the middle. its not good to share the document and get the work done.

Learn the basics as suggested earlier and try to do by your own and get help from forum for a specific task.