Hi,
I have two digital inputs, read via a DAQmx assistant, one represents a one pulse per revolution, the other
one pulse per crank angle degree (hence 360 per rev) which are generated by an optical encoder
attached to the shaft of a small engine setup.
What I would like to do is to output a single pulse 'n' crank angle (where n could be changed) pulses after
the revolution pulse. The output would be via another DAQmx assistant (ideally, as this is what I have been working
with so far). However I can only find something that will delay my signal on a time basis, rathert than sample
basis,
Any help appreciated.
Sandra