function to generate cosine and sine in FXP in Labview FPGA

[max_tomatis]

Dear Enzo,

I followed your instructions, installing with "setup.exe" in the unzipped directory in the location you mention.

I see now the palette from the block diagram, but no vi of the library yet , as in the attached figure.

Should I run also the other exe in the directories , like"WindowsInstaller-KB893803-v2-x86.exe"?

Max

---

@enpe wrote:

you have to download  .zip file that you want to unzip and place in the following location: 

--> C:\Program Files\National Instruments\LabVIEW 8.6\Targets\NI\FPGA\menus\FPGACategories 

you can proceed with the installer. After you should be like this: 

--> C:\Program Files\National Instruments\LabVIEW 8.6\Targets\NI\FPGA\menus\FPGACategories\Fixed-Point Math\ 

Containing the following .mnu files: 

--> Dir.mnu

--> BasicElem.mnu 

And so you should find the fixed-point library  in the palette.

Regards,

Enzo

---

[enpe]

But are there the .mnu files in the created folder?

Regards,

Enzo

[Donovan_B · Accepted solution]

Do you have any newer versions of LabVIEW installed on this machine?  By default, the installer will install to the latest version of LabVIEW.

[max_tomatis]

Thank you Donovan, I have uninstalled Labview 2010 and then installed the FXP library Labview 8.6,

now everything works fine.

Max