LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

fluctuating signal with usb 6212

Solved!
Go to solution
Highlighted

I am using NI USB DAQ 6212 for measuring the pressure value from MPX2010GP. The output of the sensor is the differential one varies upto 30mv. For supply voltage to the sensor, I am using the 11.2 V battery.

 

I am getting the noise at the output. But when i am measuring it with multimeter its showing a voltage with no noise. I tried connecting only the differential input and also with connecting the AI- with AI gnd. But no improvement in the signal.

 

Looking forward for suggestions to stabilize the sensor output in labview.

0 Kudos
Message 1 of 2
(522 Views)
Solution
Accepted by topic author kashifsherwani

DMMs tend to have a lot of filtering, so they will not show noise.  Try using an oscilloscope to verify the noise.


GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
0 Kudos
Message 2 of 2
(490 Views)