eth0 on sbrio-9651 not working

[lucian.grec]

I've been using the carrier board to develop/debug code for the sbRIO-9651 SOM but I´ve apparently managed to kill the Ethernet Port 0. 

The problem occurred while downloading my RT code(hence also the FPGA bitfile). There could´ve been a brown-out while doing it.

Hardware:

• sbRIO-9651
• SN 01E7A6D8
• Firmware version 7.0.0f0
• OS NI Linux Real-Time ARMv7-A 4.14.87-rt49-cg-7.1.0f0-xilinx-zynq-41

Current state:

• eth0 doesn't work, no lights, no connection
• eth1 works fine
• usb as well

Steps taken so far:

• Tried both safe mode states
• Tried re-flashing the firmware with the same version 7.0.0f0
• Deleted and reinstalled all the software packages installed on the Labview RT

I suspect a piece of software that handles the Ethernet port 0 got corrupted in the process.

Any suggestions?