01-23-2013 07:59 AM
Hi all
I work with DSC.
I can't creare the Application (EXE) with Open Trace.vi.
Best regards
Iskander
01-23-2013 08:20 AM
What's the error message when you try to create the exe?
01-25-2013 01:13 AM
Hi Paolo
Thanks
I solved this problem.
If I changed my Project I can't do Application.
If I save project, close its and then open this Project I can do Application.
Best regards
Iskander
02-19-2013 01:24 AM
Hi Paolo
My problem persists
My VI is working
But when I do EXE I receive the ERROR:
Error 1003 occurred at AB_Targetfile.lvclass:Open_Top_Level_VIs.vi -> AB_Build.lvclass:Build.vi -> AB_Application.lvclass:Build.vi -> AB_EXE.lvclass:Build.vi -> AB_Engine_Build.vi -> AB_Build_Invoke.vi -> AB_Build_Invoke.vi.ProxyCaller.
What can I do?
Best regards
Iskander
02-20-2013 09:38 AM
Hi Iskander,
What version of LabVIEW are you using? This is a known issue that was fixed in 8.2. The issue has been shown to happen when building a VI that includes a subVI containing a shared variable.
If you are using a version of LabVIEW earlier than 8.2, the best solution is to upgrade.
If upgrading isn't an option for you, here are some potential work arounds:
1. Check the Enable debugging option in the Advanced category of the application executable properties
2. Disable the Remove Panel option for all SubVIs containing Shared Variables in the build
3. Uncheck the Disconnect type definitions and remove unused polymorphic VI instances option, also in the Advanced category of the executable properties as shown below
4. Move shared variables to the top level VIs and pass the data through the SubVI connector
I hope this helps!
Regards,
Dayna P
Applications Engineer
National Instruments
02-20-2013 11:24 AM
Hi Dayna P.
Thanks
I am using LV 2011
My project has shared variables.
Best regards
Iskander
02-21-2013 12:25 PM
Hi Iskader,
It turns out that this is a known issue for LabVIEW 2011 (CAR# 306205). It was fixed in LabVIEW 2012 32 bit. There is a workaround explained in the LabVIEW 2011 Known Issues Page.
I apologize for the inconvenience caused by this issue. I hope this helps!
Regards,
Dayna P
Applications Engineer
National Instruments
02-26-2013 12:57 AM
Hi Dayna P
Thanks for the help
Best regards
Iskander