10-04-2016 01:47 AM
Hello,
I have a main-code for conductivity measuring. (AnalogDevice- Evaluation CN-0349-Kit)
Its very good and cheap solution for a "conductivity-meter".
I would like the measuring beginn every minute (for example) automaticall and consulution the program should also save the log.
But I do not get get the adjustment.
Can someone help me? (with tips/tricks/solutions, or ,or, or)
Best regards
Christian D.
10-04-2016 08:07 AM
Oh, my, you are trying to rewrite "Demo Software" provided by a vendor who may or may not know how to write good LabVIEW code, and you want to try to fix it? And you are not a LabVIEW expert (or, at least, up to CLAD or CLD level)?
You may consider some advice I've been know to give when confronted with undocumented, difficult-to-read code -- "Start Over". [I do realize this is probably not practical in your case, so here's a different piece of advice -- Find (or Hire) a LabVIEW Guru].
Bob Schor
10-04-2016 08:34 AM
Hello Bob...,
thanks for your answer.
I was hopping a "auto-mesure" is easy to implement in this software.
I thought a automaticly start (every minute) is no big deal... but I have already noticed the contary... 😞
I think it's ever good that you say difficult-to-read code...I thought just me was going there.
- with this program and corresponding modules can measure conductivity
10-06-2016 02:24 AM
I believe its possible without guru-crafts... ;:)
but my experience not enough... 😞
actuate automatic or periodic the measure-button:
If I select property "Value Signal" that then is the push automatic...or?
I get this only with ERROR-Massage (not wired...)
It should be possible??!! 😕
Can someone help me or try the variant ?
greetings
Christian
10-06-2016 04:44 AM
Crosspost in German LabVIEWForum…