can i control a DC motor by fuzzy logic with labview using daq card pci-mio-16e4 and scxi 1122 &1124,1163 modules

[ravi 614]

I want to contorl DC motor by using fuzzy logic labview software. I am using the scxi 1122, 1124 and 1163 modules, my daq board is pci-mio-16e4

[Joe acquisition]

From bsukpraphrute@yahoo.com

Your question is very broad.
What kind of DC motor are you taking about? such as small signal or power DC motor.
I could control Power vector drive DC motor using a simple PCI-MIO-16E, However, with helping of outside circuits I was be able to control the DC motor. There are many possiblities. The advance control I use DSP chip.

The answer of your question is Yes you can. I used to work with the fuzzy project. But it was a small signal motor. I hope this match your requirements.
Good Luck.
P.S. If you need a professional help e-mail me at bsukpraphrute@yahoo.com

[CarlosfgCosta]

Hi.

I’ve seen this messages and I want to control three motors with fuzzy logic controllers.

O know that LabView has libraries to with fuzzy logic controllers.

Do you have or know where to get that library?

Sincerely,

Carlos Costa

[Michael.Phillips]

Hi Carlos,

Fuzzy Logic tools are available through use of the LabVIEW PID Control Toolkit for Windows. Contact your Technical Sales Representative at 1-800-IEEE-488 for more information.