12-12-2006 06:51 AM
12-13-2006 07:26 PM
12-15-2006 06:51 AM
12-15-2006 08:02 AM
Ok really weirdness happening.
I installed the following onto the cRIO which apparently I did not have installed:
DataSocket for Labview real time 4.4
Labview PID control Toolkit 8.2
Network Variable Engine
Variable Client support.
After I did this, well, now I see the graph X scale, BUT, the maximum (default 100) shows up 1/4 of the way across the screen.
See attached pictures. I can't do anything to change it.
SHould I just reformat and re-install the entire cRIO software ?
12-15-2006 01:58 PM
Jeff,
It seems like you have all the correct software. It should work just fine even with only LV RT 8.2 and NI-RIO drivers. I would suggest formating the flash drive, ftp-ing to the flash of the cRIO to make sure there is nothing left, and reinstalling the software.
Hope that helps!
12-15-2006 02:20 PM
Jeff,
This is most likely due to an issue with the application running on the controller. If you post your code it should be easy to determine why the chart is not updating correctly. Also just a small question are you using a chart or a graph to plot the points?
Looking to help,
Bassett
12-15-2006 03:32 PM
12-15-2006 04:18 PM
Hmm...seems like it might have been a graphics glitch? Are you currently able to reproduce it again? If you can reproduce it it might be worth looking into further.
Regards,
Steve
12-18-2006 06:54 AM
Hi Steve,
Yes, all I have to do is move the graph to the right and it will do what you see in the picture.
I don't have a good understanding of the Labview workspace, since I am not that experienced with it. I just put graphs and controls wherever they end up. 🙂
Jeff
12-18-2006 04:48 PM