07-21-2021 04:57 AM
Hello,
I am using NI cRIO 9066 to control my engine injection system. The pairing between hardware and software is just fine in a particular laptop. However, I wanted to switch to another laptop and so I have downloaded and installed SCM Console 2016 (just as in the previous system). However, now there is some issue in Pairing and Finding the Target. I am able to see that the hardware is present (as indicated in the NI Max Console), however when I open the SCM Console, I am getting error messages. I have taken a screenshot of the hardware being indicated as present as well as the error messages.
Can someone throw light on this issue please?
07-26-2021 05:40 AM
Dear Sudarshan1989,
Sometimes the Windows Firewall is blocking communication for the SCM Console. Did you already run through the steps in chapter 3.2.2.4 of the manual? http://www.ni.com/pdf/manuals/NIDIDriver.pdf
Wishing you good luck!