build an alarm clock with myDAQ to control speaker and servo

[crollins15]

Hi,

I am very new to labview and would like to build an alarm clock program that can output to a speaker and a servo using a myDAQ and a protoboard. I would like to be able to make a user interface with 2 seperate alarm times, one that outputs a signal to the speaker and another that activates the servo for a certain time. Can someone please help, or provide a sample program that can be modified to solve this problem?

Thanks!

[RavensFan]

Nobody is going to have program for you or will provide you a program.

Is this a school project?

The first thing is to figure out how you would program this if you were using any kind of programming language.

Then I would recommend looking at the online LabVIEW tutorials
LabVIEW Introduction Course - Three Hours
LabVIEW Introduction Course - Six Hours

Start programing your idea in LabvIEW, then when you get stuck at a particular point, then you can post here with any specific questions you'd have.

[Dennis_Knutson]

And for questions about myDAQ, you would probably have better luck posting to the academic board. I don't think many people here are all that experienced with it and how it compares to non-academic DAQ devices.