LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Why can't I select a VI to simulate from the FPGA Execution Node?

Hi,

I have FPGA in my project tree, however when I go to FPGA Desktop Execution Node > Simulation Configuration > Select VI, I can't see any files in the project tree. Does anyone know why this is?

Student_Andy_0-1604588199691.png

Kind regards,

 

Andy

0 Kudos
Message 1 of 3
(183 Views)

Hi Andy,

 

it's hard to say without the project or at least the screenshot of the project tree... Perhaps the VI you created is not under the FPGA Target in the project tree? Maybe lack of some drivers? Just guessing.

0 Kudos
Message 2 of 3
(123 Views)

Thank you for trying to answer this question. I found out it was because the target FPGA (9066) was no longer supported in Labview 2020. So I replaced it with a a new target 9067).

 

The following shows how to do this:

 

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000P6kpSAC&l=en-GB

 

Kind regards,

 

Andy

0 Kudos
Message 3 of 3
(111 Views)