11-05-2020 08:58 AM
Hi,
I have FPGA in my project tree, however when I go to FPGA Desktop Execution Node > Simulation Configuration > Select VI, I can't see any files in the project tree. Does anyone know why this is?
Kind regards,
Andy
11-10-2020 03:48 PM
Hi Andy,
it's hard to say without the project or at least the screenshot of the project tree... Perhaps the VI you created is not under the FPGA Target in the project tree? Maybe lack of some drivers? Just guessing.
11-11-2020 03:20 AM
Thank you for trying to answer this question. I found out it was because the target FPGA (9066) was no longer supported in Labview 2020. So I replaced it with a a new target 9067).
The following shows how to do this:
https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000P6kpSAC&l=en-GB
Kind regards,
Andy