LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

What should I use for analysing E1 signal?

Hi,

 

Could someone help me and advice me what HW should I have to build in LV a tool for E1 channel analysing? I need to build a simple tool to receive, send, pass though E1 (2Mbps) signal. My tool should have two E1 ports.

 

Many thanks in advance. 

0 Kudos
Message 1 of 8
(4,916 Views)
What I used was a card from GL Communications. LabVIEW drivers are available.
0 Kudos
Message 2 of 8
(4,912 Views)
Hmm, I thought about something what can I connect to my laptop. Do you know something like that?
0 Kudos
Message 3 of 8
(4,906 Views)
I take it you didn't even bother to check out the web site I provided? Here's a more specific link.
0 Kudos
Message 4 of 8
(4,901 Views)

mimimi,

 

Another company, and probably more cost effictive then GL, you can try is DSPG

 

They make a system which can be used to analyse E1/T1 PCM streams, it can be remotely controlled from a laptop.

 

Disclaimer: I used to work for the company, however have not really had any dealings with them in several years. When I was there they had a custom designed DSP card used to simulate/analyse a telephone network (introduce echo/delay etc) on PCM trunks. I wrote a whole bunch of LabVIEW test suites for the, they could probably customise something that would suit your needs.

 

If you need a contact at the company I could probably dig out an email address.

 

0 Kudos
Message 5 of 8
(4,891 Views)

I did, but I've seen two big PCI card. Sorry, and thanks again.

 

nrp, thanks for info 

Message Edited by mimimi on 08-17-2008 10:04 PM
0 Kudos
Message 6 of 8
(4,890 Views)

No, you did not look at the link if you missed the USB solution.

0 Kudos
Message 7 of 8
(4,878 Views)

hi, 

 

Can E1 signal (2.048MHz) be interfaced with some  labview fpga module?

0 Kudos
Message 8 of 8
(3,351 Views)