03-18-2017 12:34 PM
As per the subject line, on two computers, even starting a brand new VI, if I add a Tab Control, and then try to swap or reorder the tabs, I get an undo.cpp line 471 error. Duplicating a tab and the contents is fine, the issue only appears when reordering.
Any ideas? This is Labview 2016 32 bit and I believe it is the same error in 64 bit, but it pops a different crash dialog without specifying the line number.
Is there any way to disable undo temporarily so that I can get past this and continue?
Solved! Go to Solution.
03-18-2017 12:49 PM - edited 03-18-2017 12:59 PM
03-18-2017 12:51 PM
How can I verify that is installed?
I did see another reference to undo.cpp, but it was around line 3080 or something like that...or maybe it was fpsane.cpp
03-18-2017 12:54 PM
I noticed it isn't listed in my about, so I guess this isn't offered through the Update Service? Also, the patch here:
http://www.ni.com/download/labview-development-system-2016/6358/en/
mentions 32 bit....what about 64 bit?
03-18-2017 12:58 PM
Argh, my bad...so I found the 64 bit versions and am downloading both the F1 and F2 patches right now.
Is there a reason these have been left out of the update service?
03-18-2017 01:06 PM
@raceybe wrote:
Argh, my bad...so I found the 64 bit versions and am downloading both the F1 and F2 patches right now.
Is there a reason these have been left out of the update service?
making patches available via Update service is a patch-by-patch decision internal at NI. The bugs fixed by those patches did not meet their threshold.
Or, so I was told. Frankly, an IDE Crash prohibiting the execution of a simple Right Click option with no possible workaround (Like reordering tabs in a tab container AHEM!) probably should have been escalated. But, I didn't get a vote.
03-18-2017 01:07 PM
Thanks for the prompt reply. This almost wasted my weekend.