From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I'm trying to send a simple sine wave signal to the N210. Labview will not issue an error message, but if I look at the signal on the spectrum analyzer I only see a signal that matches with my carrier frequency, but not my actual sine wave signal.It makes no difference if I change the parameters amplitude or frequency (sin), the image on the spectrum analyzer is always the same Can someone tell me where my mistake lies? Thanks in advance
