06-23-2009 09:46 AM
Solved! Go to Solution.
06-23-2009 09:54 AM
Hi icemaker,
you can build an array with the references of all your picture controls. Use a for loop to run through this array and set the option like you need it. If your picture controls overlayed, then make only one visible at the time.
Hope it helps.
Mike
06-23-2009 10:24 AM
Mike,
Bare with me because I am fairly new to Labview. The references you mention, are these the references I already made to the visibility? Also do I wire them to a 'build array' then put the array it makes inside of the loop itself?
Thanks!
06-23-2009 10:36 AM
Hi icemaker,
yes it sounds good. See the attached example, it works with leds but technically it's the same.
Mike
06-24-2009 09:29 AM
06-24-2009 10:11 AM
Hi icemaker,
do you mean like this?
Mike
06-24-2009 10:57 AM
Exactly! Thanks a million. I was trying to take value out of the timer itself instead of using it the correct way. Thanks again.