The Select Programming Mode dialogue box does not appear.in order to be able to choose the correct programming mode for my example.

[Ihab]

Dear All,

My project is howing that it discover cRIO 9075 connected to my LAPTOP

but following :

Getting Started with CompactRIO - Offloading Signal Processing with LabVIEW FPGA

http://www.ni.com/tutorial/11200/en/ 

The Select Programming Mode dialogue box does not appear.in order to be able to choose the correct programming mode for my example.

What could be the reason?

[Johnnyg17]

What version of LabVIEW are you using?

Do you have the most up-to-date RIO/cRIO driver installed?

Do you have the most up-to-date versions of abVIEW Real Time and LabVIEW FPGA installed?

[Ihab]

Hello John

I have tried on different systems

Desktop x2

Laptop x2

Labview 2013

Labview 2014

I have installed the NI-RIO Device Drivers which was delivered with my Hardware February 2015 version

NI RIO 15.0

Labview Run Time 2015

Can we have solution to this issue this week  - Pleeeeease

Thanks

Ihab

[Gregory]

So LabVIEW real-time and FPGA are not installed?

[Ihab]

NO

You are right.

But on the Desktop I have in the College is installed.

But here AT HOME  three of them are not installed.

[Johnnyg17]

http://www.ni.com/getting-started/install-software/compactrio

[Ihab_Audustry]

Hello

I followed the instruction in the link

I nstalled the 2013 Xilinx10 and FPGA and labview realtime 

It asked me to restart my computer

after restarting

I launched MAX

and I did not find FPGA and real time in the the software list

How do I verify that they are existing?

By the way I did this twice before

Thanks

[edjones93]

They should appear in NI MAX under My System -> Software -> LabVIEW 20xx as given in the attached screenshot.

[Ihab]

this is the eror appars during installatin

[Ihab]

also this message appears after adding new target and device