05-09-2021 01:52 AM
Dear all,
I am trying to use Tab controls to
i) 'configure' the DAQ and VISA devices for a measurement,
and then
ii) run the measurement using a sub-VI based on producer/consumer loop, in another tab.
For this I want to transfer the set parameters from the 'config tab' to the 'measurement tab'. Question, is how to implement this.
See attached images and VI.
________________________________
i) Config tab
ii) Alignment tab
___________________________
Thank you.
Solved! Go to Solution.
05-09-2021 05:41 AM
Not sure I understood your problem but if you want to have access to the DAQmx controls in multiple cases, why not placing the controls outside of the case structure?
05-09-2021 08:44 PM - edited 05-09-2021 08:53 PM
Thank you for the suggestion. I think this will work.
05-09-2021 11:45 PM
A tab control is mostly a way to organize front panel elements. There is typically no need to wire it to a case structure or anything else. Just program as if all controls and indicators are on a flat front panel.
05-10-2021 12:40 AM
Thanks for the reply.