LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

TTL signal with NI 9381 device

Hi,

 

I want to control a TTL input with the NI 9381. It allows you using a digital output.

 

I have measured the output signal and it was 2.8 V. The control has failed and I think that 2.8 is not enough to control a TTL input.

 

The device specifications:

Output high, VOH Sourcing 100 µA..................2.7 V

 

Could anybody help me?

0 Kudos
Message 1 of 4
(3,037 Views)
What is the specification of your signal sink?
What do you want to drive with your digital output?
Best regards,
GerdW


using LV2016/2019/2021 on Win10/11+cRIO, TestStand2016/2019
0 Kudos
Message 2 of 4
(3,008 Views)

Hi GerdW, thank you for answer.

 

I want to turn on and off an equipment. The equipment manual says: The voltage applied to the REMOTE BNC connector must not exceed 5.5 V.

 

So, I want to send 0 or 1 (0 or 5 V) to turn on and off.

 

I do not know if I have answered your question. If have not done, ask me again, please.

 

Best regards

0 Kudos
Message 3 of 4
(3,001 Views)

Hi srglzal,

 

when you want a 5V output signal you should

- at first read the manual, especially page 20, with the specifications of your module

- then build a small amplifier to convert from LVTTL to TTL levels…

 

RTFM!

Best regards,
GerdW


using LV2016/2019/2021 on Win10/11+cRIO, TestStand2016/2019
0 Kudos
Message 4 of 4
(2,939 Views)