Sensor Calibration in LabView

[nalsis]

Hi, I'm having trouble trying to calibrate the SingleTact pressure sensors using myRio / LabVIEW.

I'm new to LabVIEW and getting confused how to design the programme. 

My project is to design a low-profile trackpad for finger gesture detection, where I can detect finger contact on a surface of 100 x 100 mm and plot the resultant signal data on the GUI.

Any help will be gratefully appreciated.

regards,

Nalsis

[RavensFan · Accepted solution]

The first step is sitting down with pencil and paper and writing out the series of steps that your program will be doing.  Make a simple flowchart, or write it out in pseudocode.

[nalsis]

Hi RavensFan,

Thanks for your starting recommendation.