From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Sending data via UART - Too quick, works only with WAITs

Re: Re.: Sending data via UART - Too quick, works only with WAITs

‎05-04-2018 09:17 AM

I did say "this might be ...."

Smiley Wink

 

0 Kudos
Message 11 of 12
(234 Views)
Reply

Re: Re.: Sending data via UART - Too quick, works only with WAITs

‎05-04-2018 10:16 AM

My problem was the sending of the characters 😉 I will leave the scan for the Hit any key as it is, because it works at the moment. If it fails I have a lot of alternatives.

 

I got rid of the VISA OPEN, the buffer flush, the buffer size settings and the 200ms wait-ms. Still the same: After 14 or 13 chars my transmitted message gets cut off. I leave it like (with the delays) it is or try it with another UART and see, if the behaviour depends on the interface.

 

kind regards,

Christian

0 Kudos
Message 12 of 12
(224 Views)
Reply