04-17-2008 11:38 PM - edited 04-17-2008 11:46 PM
Routing AI Start Trigger to an Output Terminal
You can route ai/StartTrigger to any output PFI terminal. The output is an
active high pulse.
I am using Visual C++ . What is the API to connect or disconnect one internal signal to another?
If I use this as a trigger source and route ai/StartTrigger to PFI0 for example, I expect an active high pulse at the PFI0 pin. Is my understanding correct?
Thanks and regards,
A
04-17-2008 11:47 PM
angelmcdoggie wrote:
Dear All,Page 20 of the NI CDAQ-9172 User Guide &
...... & what else... ?!
http://forums.ni.com/ni/board/message?board.id=170&thread.id=317102
http://forums.ni.com/ni/board/message?board.id=170&thread.id=317101
http://forums.ni.com/ni/board/message?board.id=170&thread.id=317100
http://forums.ni.com/ni/board/message?board.id=170&thread.id=317099
http://forums.ni.com/ni/board/message?board.id=170&thread.id=317098
http://forums.ni.com/ni/board/message?board.id=170&thread.id=317097
http://forums.ni.com/ni/board/message?board.id=170&thread.id=317096
http://forums.ni.com/ni/board/message?board.id=170&thread.id=317095
04-17-2008 11:49 PM
04-17-2008 11:49 PM
04-18-2008 01:57 PM