Refreshing TEDS

[Johan1300]

Hello!

Ive made a program that collects the information in TEDS sensors with an NI RIO 9233, the only problem is that when I change to another sensor or the direction of the sensor

I dont get any new results. Then I need to restart in the Measurment & Automation explorer.

So my question is if there are any function directly in labVIEW where I can either restart or refresh the configuration of the NI USB device?

I am a little bit new with labview so take it slow 😉

best regards

Johan G 

[Bjorn_Beckman]

Hi

To programatically reboot your cRIO:

http://digital.ni.com/public.nsf/allkb/25825D24D1DF688D8625709D0053FF68?OpenDocument

Reset DAQ device

http://digital.ni.com/public.nsf/allkb/124D580AE300335E86256FDD006CE798?OpenDocument

Hope this helps.

Best Regards

Bjorn