LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Real-time frequency and amplitude

Highlighted
Hi, how would I go about obtaining the real-time frequency and amplitude of a measured signal (current feedback from the NI 9505 current sense module in this case)? I am using the cRIO-9022 in conjunction with an NI 9505 to control and measure feedback from a voice-coil motor intended for the foot. Current is being sampled using the current loop example vi. As mentioned, I am measuring current feedback from the voice-coil via the current sense module of the NI 9505 in real-time and I would like to obtain the real-time frequency and amplitude of this current signal. Thanks
0 Kudos
Message 1 of 2
(886 Views)
Highlighted

Hendrick,

 

Do to the nature of your question revolving around the cRIO and real time measurements, your post would be better suited being posted in this forum: http://forums.ni.com/t5/Real-Time-Measurement-and/bd-p/280

 

Regards,

 

Larry H.

Applications Engineer
National Instruments
0 Kudos
Message 2 of 2
(842 Views)