05-22-2019 01:27 PM
Hi all,
I've got an Omega TQ513 torque transducer (user manual scan attached) that I'm trying to read and record via LabVIEW. The output of the sensor is 2.0 mV/V, so I believe I can use NI-9237 to accomplish what I'm after; can anyone confirm that by chance?
Any advice on this one is greatly appreciated!
05-23-2019 11:03 AM
That looks like it will work just fine. The manual looks like it is a full bridge output and the NI-9237 will read full bridges.
11-07-2019 07:31 PM
Hi,
Did you have any luck with the setup?