NI- Motion related issue

[sameermathe]

HI

I am facing some issues after upgrading to LabView 15 , i am using Pxi-8840 and motion controller 7350.

some of the VI's as stated below are missing.

1) Motion error handler.flx 

2) reset position.flx 

3) Initialize controller.flx 

I had installed NI-Motion 14 ,18 and 8.1 can you suggest how can install missing VI's. 

[sameermathe]

HI

I am facing some issues after upgrading to LabView 15 , i am using Pxi-8840 and motion controller 7350.

some of the VI's as stated below are missing.

1) Motion error handler.flx 

2) reset position.flx 

3) Initialize controller.flx 

I had installed NI-Motion 14 ,18 and 8.1 can you suggest how can install missing VI's. 

[Bob_Schor]

Please do not hijack the thread "NI MAX could not launch" and give it your new name -- start your own (named) thread.

If you read completely the hijacked thread, you would see that a scatter-shot approach to installing LabVIEW versions and drivers ("I had installed NI-Motion 14 ,18 and 8.1 can you suggest how can install missing VI's. ") is fraught with problems.

My recommendation would be the following (and it would probably work):

• Uninstall all NI Software.
• Reboot.
• Install a single Version of LabVIEW, including NI-Motion for that Version.
• Reboot.
• Install the necessary drivers for your hardware, including the PXI controller and Motion support.
• Reboot.
• Try to compile your code.

Bob Schor