06-14-2017 03:22 PM
Hi
I have a question about linx, i hope someone can help me.
I made a project, and i´m using LINX but every time I run the program I have to log in to - tools-makerhub-linx-firmware and load it to the arduino uno, my question is, if there is any way to leave this firmware recorded on the card and not have to redo all These steps.
Thanks for read ...
Regards.
06-15-2017 04:36 PM
Hi OmiAmador,
Can you send us screenshots? It would be also useful to post this question in MakerHub forums if you havn't done so: https://www.labviewmakerhub.com/forums/viewforum.php?f=12