04-29-2008 07:46 AM
04-29-2008 08:52 AM
Hello,
I'm not sure but it may solve your problem. There's an example called AVI Read Write with data example in LabVIEW help (Toolkits -> VISION->Function->AVI Read Write with data example ) that allows tou to display an AVI file in a IMAQ Image and in which you can set the image number of the avi file you want to display. But for this I think you need VISION toolkit.
Hope this helps ...
Regards,
Sébastien DURAND
04-29-2008 10:29 AM
Hello Sebastian,
thanks for your answer, it helps me yes and no. On the computer i am currentlx working, there is vision installed, but i would like to run the Vi in future on a computer without Vision, but for the moment that is exactly what i need. I modified it a little to get an offset for the starting point.
Again, thanks for the hint!
Lord Chaos
04-29-2008 12:49 PM
04-29-2008 01:10 PM
04-30-2008 05:38 AM
04-30-2008 06:09 AM - edited 04-30-2008 06:11 AM
04-30-2008 06:51 AM
04-30-2008 08:44 AM
Yeah, its fairly easy...
1. Right click on the green terminal on the block diagram
2. Select Create->Property Node->Container Bounds->All elements
3. Wire a Bounds constant (or control if you want to be able to adjust it) into that property node.
I suggest adjusting the bounds at the end of the process.
04-30-2008 09:24 AM
Thanks for your reply
Ok, the problem that i was not able to set the hight and width, was that i used the "normal" bounds property.
But unfotunatelly that didn't solve my problem. I have attached two picutures, in the non running mode, you see the frontpanel with the active X container in whcih size i want to pay the movie, but when i run the VI, the video size enlarge up to 600x400 which is the size of movie...
Any more ideas?
Thanks Lord Chaos