11-22-2012 01:07 AM
Dear all,
I created an application to open multiple instances(RecipeEditor.vi as attached)works fine in debug mode. But, after I build it to an exe, it gives me error 1003.
Can you please show me some pointer what is wrong?
Please find attached zipped package
Thank you in advance.
Regards,
Vincent
11-22-2012 02:57 AM
your Recipe Editor seems to be password protected!
11-22-2012 06:15 AM
Yes, LV. Will that cause errorcode 1003?
11-22-2012 06:39 AM
No, error 1003 is not likely to be created by password protection.
You have to either unlock the VI and post it again or tell us the password. Otherwise, we can only guess about reasons.
Norbert
11-22-2012 09:30 AM
Do you include the vi in the build ?
How do you find the vi and get a reference ? by relative or absolut path ?
Is the path correct in the exe ? remember that the path in a exe most likely is NOT the same as in the dev. environment.
11-22-2012 09:30 AM
OIC.
Please find attached unlocked file
11-22-2012 09:37 AM
Sadly, there is still an non-empty password configured....
11-22-2012 11:01 AM
my apology, Norbert.
I attached the wrong file. This attachment is password removed.
Thank you in advance
11-22-2012 11:17 AM
dk,
Thank you for your reply. I am relatively new in Labview.
I did include the vi in build
vi is by absolute path
11-22-2012 03:44 PM
What are you entering in the vi path control that you have, when you run your exe?
And just a tip, start trusting the data flow. You are using too many sequence structures, that has no meaning.