LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Not displaying the value to the instrumens that I am entering in the lab view

Hi,

 

I am very new to lab view. I don't have much idea about it. There is an existing lab view program in my lab's computer which controls Wavetek 50Mhz pulse function generator. There is communication between the lab view and instrument but is not displaying the value on function generator that I am entering value in lab view. I don't know what is wrong with these two. I have attached my  lab view program here with.The two pictures here belongs to one block diagram. Any help will be highly appreciated. Thank you in advance.

Download All
0 Kudos
Message 1 of 3
(788 Views)

It is called LabVIEW not lab view. Photographs and pictures are not useful to debug a program (with rare exceptions), except that we can tell here that this was not written very professionally.

 

  • Do you know who wrote it?
  • Are there instructions how to use it and connect everything?
  • Do you actually run the program and just changing controls in edit mode?
  • Are there error messages?

 

Please attach the actual VI, tell us exactly how everything is connected and how you use the program.

0 Kudos
Message 2 of 3
(753 Views)

Thank you for correcting me. I am not sure who had written this. As far as I know, there are no any instructions how these are connected. When I put some value of my input voltage and tried to run the program, there was no any error messages which means program is communicating with instrument. But the problem is, instrument shows in remote mode but do not display the value the one that I am writing in my LabVIEW which I think it should. I am not sure if you are asking for .vi file. If so, I am attaching here with. I hope this may help. Thank you.  

0 Kudos
Message 3 of 3
(732 Views)