No daqmx vis in measurement i/o in Labview 8.5 after install

[Macl10]

Labview 7.1 also resides and can them. How to fix for 8.5? Running NiDaq 8.7.1 Tried copying Daqmx folder from vi.lib under program files\7.1 to 8.5  Tried same for Nidaq Mx.mnu under menus\default. Also for folder daqmx under menus folder. Any ideas?

[Seth_B.]

When you installed LabVIEW 8.5, did you then run the NI-DAQmx installer?  In order to get DAQmx support for a newly installed version of LabVIEW, you'll need to run the installer again so that the installer can add support.

[Macl10 · Accepted solution]

I installed 8.5 along with 8.7.1 drivers that were on the same disk(DVD). I was using 8.7.1 with LV 7.1 I'll try re-installing drivers from a separate Nidaq disk

Thanks

[Macl10]

Thanks Seth. That fixed it. i was suprised though since I set the install to install drivers when i installed 8.5. Guess it still needs to after the fact.

Thanks again