LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

New and need help with keithley 2700 GPIB threw labview 2010

Hello everyone,

I have the drivers for the keithley 2700 dmm and its ok with labview idntifying the device.

but when im trying to run the "Keithley 27XX Single Measurement.vi" and take a single resistance measurment

I always get this error, (pic related)

can anyone help please?

 

btw, where can i start learn from zero how to program in labview in GPIB protocol (not visa) ?

thanks alot.

E.

0 Kudos
Message 1 of 3
(2,379 Views)

Zerez,

 

Definately search the forums as I found another forum wher they tried troubleshooting a 2700 that was locking up. Unfortunately a resolution wasn't determined. 

http://forums.ni.com/t5/Instrument-Control-GPIB-Serial/keithley-2700-7700-4-wire-Measurement-GPIB/td...

 

Can you use max to request values from the device? Using visa test panels. It should reply to the identification command if it is functioning properly.

Kyle Hartley
Senior Embedded Software Engineer

0 Kudos
Message 2 of 3
(2,359 Views)

Also here's a document that covers various methods of using GPIB and ways of verifying the outputs.

http://sine.ni.com/np/app/culdesac/p/ap/ictrl/lang/en/pg/1/sn/n17:ictrl,n21:25/docid/tut-4293/

Kyle Hartley
Senior Embedded Software Engineer

0 Kudos
Message 3 of 3
(2,352 Views)