i'm triyng to set up a synchronized acquistion system composed by a pxi 5122 and a pxi 6133 boards. The system should be configured to get a trigger on the pxi5122, export it to the pxi6133 and perform a simultaneous acquisition of the two boards. Unfortunately, the settings i use (ConfigAcq.vi is the vi though wich the boards are configured) are not working, since after few minutes of acquisition i get a Error-200284, wich cause the whole program to crash. The acquisition is performed in the timed loop represented in AcquisitionPicture.png.
I think some setting is incorrect, but i cannot figure out where nor what has tho be changed.
Thank you for your help!
The Labview Error-200284 is product of: Some or all of the samples requested have not yet been acquired. So,try to check:
1) Sample rate
2) Timing and trigger configuration.
I hope this will be helpful for you.
Did you solve the problem?