Rif.: NI Scope and DAQmx synchronization

[MattiaBeretta]

Hi everyone,

i'm triyng to set up a synchronized acquistion system composed by a pxi 5122 and a pxi 6133 boards. The system should be configured to get a trigger on the pxi5122, export it to the pxi6133 and perform a simultaneous acquisition of the two boards. Unfortunately, the settings i use (ConfigAcq.vi is the vi though wich the boards are configured) are not working, since after few minutes of acquisition i get a Error-200284, wich cause the whole program to crash. The acquisition is performed in the timed loop represented in AcquisitionPicture.png.

I think some setting is incorrect, but i cannot figure out where nor what has tho be changed.

Thank you for your help!

Mattia

[AndresA]

Hi Mattia,

The Labview Error-200284 is product of: Some or all of the samples requested have not yet been acquired. So,try to check:

1) Sample rate

2) Timing and trigger configuration.

I hope this will be helpful for you.

Andres

[AndresA]

 Hi Mattia,

Did you solve the problem?

Thanks,

Andres