LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

NI 9862 and DMA FIFO

Hi to you all. We're trying to compile a FPGA file with 3 DMA into the project and a NI 9862 into the RT part (cRio 9116). During the compilation process we always have this error: Too many sets of DMA control lines have been requested or some requests are conflicting

We tried to follow the following solution (http://digital.ni.com/public.nsf/allkb/9B13EF13482F4EEC862578FE006EB4C2?OpenDocument) but we still have the same problem.

We're running Labview 2012sp1.

 

Regards

0 Kudos
Message 1 of 3
(2,357 Views)

Hello Domenico,

 

Are you attempting to use the FPGA in hybrid mode with the scan interface? If you are, the scan interface requires 2 DMA channels, which could be the source of your error. I wasn't able to open your link, so my post may be off the mark.

Ian K.
Software Developer
Data Ahead AG
0 Kudos
Message 2 of 3
(2,353 Views)

Hi, we're using the system in FPGA interface.

Sorry about the link, it's: http://digital.ni.com/public.nsf/allkb/9B13EF13482F4EEC862578FE006EB4C2?OpenDocument

0 Kudos
Message 3 of 3
(2,350 Views)