From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

NI 9237 Strain gage module with NI 9945 FPGA

NI 9237 Strain gage module with NI 9945 FPGA

‎05-30-2013 11:35 AM

Hello,

 

I use the continous DMA to read data from a strain gage. Now when i try do enable the half bridge settings on the module for using the ni9945 nothing happens. Even after compiling en deploying the settings it seems it doenst allow me to change it. I tried to change the output voltage of the module but it stays on the original value. Can anyone see the problem?

I attached the project.

 

Kinds regards,

lode

0 Kudos
Message 1 of 1
(2,040 Views)
Reply