LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

NI 9236/7 Offset Correction through hardware

Hi,

 

I understand that it is possible to perform the offset correction through software using the method shown in the NI 9236 getting started project, but is it possible with either of the above modules to perform this calibration through the hardware so that the signal range is not affected?

 

I'm using cRIO 9038, LabVIEW 2015.

 

Thanks

 

Chris

0 Kudos
Message 1 of 3
(1,468 Views)

Hello

 

It is not possible to offset correct through hardware, unless done by a certified professional. I would reccomend either doing it through the method shown in the Getting Started guide, or through NI MAX Self Calibration.

Thank you

0 Kudos
Message 2 of 3
(1,413 Views)

Hi SasounT,

 

Thanks for your reply.

 

Just to clarify, when you refer to the certified professional, you mean that electronics would need to be integrated into the sensor wiring prior to the signal getting to the module?

 

Cheers

 

Chris

0 Kudos
Message 3 of 3
(1,400 Views)