LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

NI 5783 Analog output

I am new to labview and fpga programming. I want to try and use my NI 7972 with NI 5783 adapter module to generate a 300Khz sine wave. I am currently using the getting started vi. For signals 1 MHz and above, I get the correct signal on my oscilloscope, however, for anything below 1 MHz my signal is all messed up. I am using 50 Ohm cables as recommended by NI. Anyone know why this is happening?

Here is the output when I set the frequency to 900 Mhz (square)

1M output oscilloscope.jpg

200kHz

200K oscilloscope.jpg

for 1MHz and anything above, the signal is correct:

341951405_1041579160150023_3391667126846909034_n.jpg

 

0 Kudos
Message 1 of 1
(453 Views)