From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Miscellaneous Operation Failure when installing XNET to cRIO

Miscellaneous Operation Failure when installing XNET to cRIO

‎02-03-2020 11:47 AM

I am fairly new to LabVIEW and I am trying to us a NI-9860 with a cRIO-9045. The module doesn't work with FPGA so I have it listed as a Real Time Resource. Research I have done says I need to use XNET to use this module. I am able to install XNET on my computer but when I try to install it to the cRIO it always fails at the same point and I get this error message.

 

 

Error.PNG

Without XNET installed on my device I don't think I can use this module for CAN messages. What could possible be the cause of this error and how could I fix it?

 

Thanks in advance for any advice or help for this problem!

0 Kudos
Message 1 of 1
(1,746 Views)
Reply