LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Low frequencies

Hey,

 

I created an audio recording system in LABVIEW. I bought an output-receiving microphone with frequencies 20HZ-20kHZ.

When I play a frequency above 100HZ the software writes it accordingly. But when I play a frequency below 100 Hz the software doubles it by 3.

For example, when I played a frequency of 60Hz the software recorded it as 180HZ.

First I would like to know why.
And secondly I would love a solution so that the frequency that is heard will be displayed as it is.

 

Thanks

0 Kudos
Message 1 of 2
(127 Views)

vi?

 

if you used tone detection (td) and provide only a short slice of data  (<=10ms, maybe <20ms due to window of fft in the td vi), the td vi will detect the next highest frequency. Usually the 3 harmonic created by your setup 😉

 

take a look at the FFT of a window at least 20 periodes of your signal.  Do you find THD?

Greetings from Germany
Henrik

LV since v3.1

“ground” is a convenient fantasy

'˙˙˙˙uıɐƃɐ lɐıp puɐ °06 ǝuoɥd ɹnoʎ uɹnʇ ǝsɐǝld 'ʎɹɐuıƃɐɯı sı pǝlɐıp ǝʌɐɥ noʎ ɹǝqɯnu ǝɥʇ'


Message 2 of 2
(111 Views)