04-09-2017 02:10 PM
I am trying to make a proof of concept to show how a labview webservice is created on an sbrio. as you can see from the screenshots, I keep getting the error message when I try to run the VI to see if it is working. When I move the VI to a different location like under My Computer, it runs but not under the webservice and thus under the sbrio. the VI actually deploys to the sbrio. any ideas??
04-10-2017 04:15 PM
Try simulating the FPGA target and see if it can run without errors. You can do this by right clicking the target > Execution Mode > Simulated. This will give you garbage data, but if the VI can run then your code is fine and there is likely something going wrong with the hardware.
Danielle
National Instruments