04-07-2014 02:36 PM
Hello Forums!
I have to write a LabVIEW code to read the Instron 3360 to compress a thin-walled cylinder. The cylinder is expected to withstand about 500lb. How do I go about doing this?
- Thanks!
- gibiv (high school student)
04-08-2014 06:53 PM
Can you tell me a little more about your application? More specifically:
1. What is the input/output of the instrument you are using to measure force?
2. Are you using NI Hardware to communicate with this device?
3. What drivers are you using?
4. What version of LabVIEW are you using?
I have included some general information below about configuring a data acquisition system in LabVIEW.
Introduction to Data Acquisition: http://www.ni.com/white-paper/3536/en/