LabVIEW communication with Gafran controller can some one help me

[Focos]

LabVIEW communication to Gefran controller ca some one help me ?

[aeastet]

We need more information.

What controller do you have?

[Focos]

The controller is

650-D-R-R-0-01-G

and

650L-R-R-R-0-0-1-0-1-1-1-1-G

[aeastet]

Reading on these they look like they are using:

RS485 serial communication in Modbus RTU

LabVIEW has a Modbus module that you can download.

http://www.ni.com/example/29756/en/

This should get you started. Use the manual. It should have the commands that you can access.

[Focos]

Yes I know that the Modbus RTU is there but I need someone who can setup all the adresses for Setpoint Procesvals alarms ext. ext.

I am not an expert so I need help. 🙂

[cbutcher]

I think at this point you effectively have two choices:

1. Become an expert (or at least, learn some LabVIEW (see the top of the forum board for links) and then try things until you have a working program, or at least more specific questions)
2. Hire an expert: LabVIEW Job Openings subforum

Without a specific question, I doubt you'll find someone here willing to remotely write your entire application for free.

It may be possible to get better help if you read about the Modbus librar(y,ies) available for LabVIEW, the structure of Modbus communication, and make a (potentially quick) attempt at the problem, then come back with a specific error or difficulty.