LV RunTime: "vi is broken or one of it's subVIS can't be located"

[JoVMo]

I made a deployment image in TST 2010 DE. I used the LV2011 disk to copy the LV RT images. In the config the RT engine was set to LV2010.

I wrote the test vi in LV2011. Then I added it to a lvlib and then loaded it in TST. This ran under the DE from TST and LV. Then I made the deployment.

The test vi was under version 2011 and it resided some custom controls, spreaded across different directories on the network drive.

[JoVMo]

When I use the "FP.winbounds" property in my vi the RT2010 reports a broken vi? When I remove this property it runs.

[JoVMo]

Forget my last reply. I can't write to winbounds at RT.

[JoVMo]

Can I use cvt with the RT engine? It's better I install the DE?

[Pachi]

CVT is supported by the Full Development System. I am not sure if the functionality is extended to CVT. You'll have to check on it. But since you are extensively using LabVIEW, why dont u go ahead and install the DE?

Regards,

[JoVMo]

Tnx Pachi,

I think it's a good idea. 🙂

[Pachi]

Glad I could be of help 😉

Regards,